Bounce house blower delivers big laptop cooling gains in modder test
A modder known as Trash Bench attached an inflatable play equipment blower to a gaming laptop and cut GPU temperatures from 84 to 48.8 degrees Celsius, according to Tom's Hardware. The extreme airflow brought only small performance gains over far quieter setups.

Key takeaways
- A modder called Trash Bench cooled a gaming laptop with a bounce house blower, cutting GPU temperatures from 84 to 48.8 degrees Celsius.
- The Llano V12 cooling stand already improved gaming performance by an average of 19.4% at medium settings.
- In Time Spy benchmarks, the blower and several quieter fan setups finished within 1% of each other.
- The modder notes that extra airflow stops helping once a limit other than temperature takes over.
In this article
An unusual laptop cooling experiment
A PC modder who goes by Trash Bench has cooled a gaming laptop with a blower designed to inflate bounce houses, according to Tom's Hardware. The experiment brought the laptop's GPU down from 84 degrees Celsius to 48.8 degrees Celsius, a drop of about 35 degrees.
The machine in question uses an Intel Core i7-10750H processor and an RTX 2070 MaxQ graphics chip running at a 90W power limit. In Cyberpunk, the frame rate rose from 47 FPS to 56 FPS with the extra airflow in place.
Trash Bench was sent a laptop cooling stand to review, but he does not make reviews. Instead, he set himself a challenge: test the cooler, then try to beat it with his own creations. The rules were strict. He could not open the laptop or use any cooling below ambient temperature. Only airflow was allowed.
The cooling stand set a high bar
The Llano V12, the laptop cooling fan he was sent, proved hard to beat. At medium settings it held the GPU to an average of 58.3 degrees Celsius, well below the stock figure of 84 degrees. The lower temperatures also lifted gaming performance by an average of 19.4%.
Running the Llano V12 at full speed made it very loud, yet it managed only 56.7 degrees Celsius, with gains so small they hardly mattered. That result set the target for everything that followed.
Bigger fans, mixed results

The first challenger was a Noctua NF-A20, a 200mm fan, paired with a 3D-printed duct and foam edges to stop air escaping. It averaged 66.3 degrees Celsius on the GPU, so it lost to the Llano V12, though the result was still respectable for such a simple setup.
Next came six Arctic P12 fans running at full speed. They beat the Llano V12 at medium settings by 0.9 degrees Celsius, reaching an average GPU temperature of 57.4 degrees Celsius. Even so, they fell just short of the Llano V12 at full speed.
The third attempt used two server fans spinning at 4000 RPM. They were even louder than the six Arctic fans, but they finally won, finishing 2.6 degrees Celsius ahead of the Llano V12 at full speed.
The bounce house blower goes extreme
To finish the series, Trash Bench turned to a powerful blower meant for inflating bounce houses. He reused the larger foam gaskets from the Llano V12 and 3D-printed an interface on the bottom of the cooler housing to fit a flexible duct.
The airflow was so strong that it lifted the laptop off its stand. He had to tape the machine down to seal the leak. With the blower running, the GPU averaged 48.8 degrees Celsius.
The temperature win did not translate into a large speed boost. In Time Spy benchmark results, the bounce house blower, the Llano V12 at full speed, the six Arctic fans and the two server fans all landed within 1% of each other. The Noctua setup trailed the blower by 3%, but it was far quieter.
Why the extreme result matters less than it looks
Tom's Hardware reports that Trash Bench himself points out the limits of the experiment. Once heat no longer holds the hardware back, something else does, such as power limits, so pushing more air in stops paying off.
That explains why a 35-degree temperature drop produced only a modest frame rate gain over much smaller coolers. For anyone considering laptop cooling add-ons, the takeaway is that a good cooling stand can capture most of the benefit without the noise, the tape or the bounce house equipment.
Sources
Spotted a mistake? See our corrections policy. Read how News by OnDevice works in our editorial policy.



