Solar panel types compared: monocrystalline, polycrystalline and thin-film
Monocrystalline panels produce the most power per square foot, but roof space, shading and budget often decide which solar panel type suits a home, according to Engadget.

Key takeaways
- Monocrystalline panels produce more power per square foot than polycrystalline models, which need more roof space.
- Thin-film panels suit unusual mounting but are rarely chosen for a standard pitched roof.
- Shade, heat, roof orientation and utility rates can matter more than headline efficiency.
- The average US residential installation cost $3.36 per watt in the second quarter of 2026, per SEIA figures cited by Engadget.
In this article
What the three panel types offer
Monocrystalline panels are made from a single silicon crystal and deliver more power for each square foot than older polycrystalline models, Engadget reports. Polycrystalline panels may cost less where they are still sold, but they need more roof area to match the same output. Thin-film panels use thin layers of photovoltaic material, and some are flexible and light enough for unusual mounting, though they are rarely the first pick for a standard pitched roof.
The comparison matters most on crowded roofs. Skylights, chimneys and vents already claim some of the sunniest spots, so the panel that fits the remaining space can count for more than the one with the best brochure figures.
Why the most efficient panel is not always the best buy

Engadget notes that a more efficient panel does not automatically make it the right choice. Household electricity use, shade across the roof and the rate a utility pays for surplus energy all change the calculation. The article points to a 20 percent rule for sizing a system, which means allowing capacity to generate roughly a fifth more energy than the home normally uses as a buffer for duller days.
Heat also works against output, since panels tend to lose efficiency as they warm up. Shading and the direction the array faces can cut annual production too. Bifacial panels can capture reflected light from behind, but Engadget says that gain depends heavily on how they are mounted and on the surroundings.
Cell technologies and quoted efficiency
Modern monocrystalline panels use cell designs such as TOPCon, HJT and PERC. Most are not built on entirely new materials, but each aims to lift cell performance in its own way. Engadget cites Qcells' n-type Q.TRON BLK M-G2+, rated at 440W with 22.5 percent module efficiency, and Tesla's 420W residential module at a minimum of 20.5 percent.
Those figures are not a like-for-like contest, because panel size differs between products. Engadget adds that neither vendor's specification sheet shows how much power a panel will produce on a particular roof.
What a system costs and how to judge a quote
The Solar Energy Industries Association put the average US residential installation at $3.36 per watt in the second quarter of 2026, according to Engadget. The article also describes an editor's own 5.1kW system, which came to a little over $24,000 once checks and official approvals were included.
The federal residential clean energy tax credit no longer applied to systems finished after 31 December 2025, though some state and local incentives may remain. Engadget advises weighing performance warranties as carefully as the upfront price, because panels usually degrade gradually rather than failing outright after a few years.
When a portable power station makes more sense
A permanent rooftop array is a large commitment, and backup power is a different goal from trimming a monthly bill. For outages, Engadget suggests portable power stations from Anker SOLIX, Jackery, BLUETTI and EcoFlow. These units can recharge from one or more compatible solar panels and keep a limited set of appliances running during a cut.
Engadget's overall guidance is to match the panel type to the roof, the budget and the reason for going solar, rather than choosing on efficiency alone.
Sources
Spotted a mistake? See our corrections policy. Read how News by OnDevice works in our editorial policy.



