NGINX vulnerabilities could allow remote code execution
Xint reports five critical NGINX flaws, including one that may allow unauthenticated command execution when HTTP/2 is enabled. Xint also reports a kernel privilege escalation issue that could lead to root-level control if chained with the NGINX flaw.

Key takeaways
- Xint reports five critical NGINX vulnerabilities, according to LWN.net.
- The most serious flaw may allow unauthenticated command execution when HTTP/2 is enabled.
- A separate kernel privilege escalation issue could lead to root-level control if chained with the NGINX flaw.
- Xint recommends NGINX 1.31.9 and disabling unused SCTP modules until a kernel fix exists.
In this article
What Xint reported
According to LWN.net, Xint has reported five critical NGINX vulnerabilities. NGINX is a web server, which is software used to deliver websites and applications. The company says the worst flaw could allow command execution without authentication. That means an attacker would not need to sign in first.
Command execution means the attacker can make the server carry out instructions. The issue is tied to NGINX servers with HTTP/2 enabled. HTTP/2 is a version of the protocol used for web traffic.
LWN.net presents the information as Xint's findings. The summary highlights the most serious NGINX issue. The findings are claims from Xint.
The kernel escalation risk

Xint also reports a local privilege escalation vulnerability in the kernel. The kernel is the core part of an operating system. Privilege escalation means moving from a lower level of access to a higher one. The flaw is in the Stream Control Transmission Protocol, or SCTP, subsystem, which Xint says was introduced in the 4.15 kernel.
The report says the NGINX issue and the kernel issue could be used together. This is called chaining. If chained, an attacker could obtain root-level control of the host. Root-level control gives full control over the system.
LWN.net notes that no kernel fix has been released yet. The kernel issue is separate from the NGINX issue, but the report says the two could be combined.
Who is affected
The remote code execution issue matters because it could let an attacker run commands on an NGINX server. The report says the affected server must have HTTP/2 enabled. This makes the setting an important detail for administrators to check.
The kernel issue matters because it could turn limited access into full control. Xint says the SCTP flaw affects systems running the affected kernel code. Hosts that do not need SCTP are advised to disable the module until a fix is available.
Administrators should identify which NGINX servers have HTTP/2 enabled. They should also identify which hosts load the SCTP module. The NGINX issue is described as affecting servers with HTTP/2 enabled.
What to do next
Xint advises moving to NGINX 1.31.9. The report says this version has just been released. It is the main upgrade named as the response to the NGINX flaws.
For the kernel issue, Xint advises disabling the SCTP module on systems that do not use it. This is a temporary measure because no kernel fix has been released yet. Updating NGINX addresses the reported web server issue. Disabling unused SCTP support addresses the reported kernel issue while no patch exists.
The report includes a mitigations section with more information. Readers should consult that section and official vendor guidance before making changes.
What remains unconfirmed
The findings are attributed to Xint by LWN.net. The report summary does not include independent verification. It also does not provide a kernel fix at the time of writing.
Because the kernel fix is missing, the suggested SCTP blocking step may be relevant for teams that cannot update NGINX immediately. However, the report's main software recommendation remains NGINX 1.31.9.
Sources
Spotted a mistake? See our corrections policy. Read how News by OnDevice works in our editorial policy.



