Apple HomeView teardown finds glue-heavy design that resists repair
iFixit's disassembly of Apple's smart display turned up strong adhesive, mixed screw types and torn speaker cables, according to GSMArena. The report describes a device that is harder to open than other recent Apple hardware.

Key takeaways
- iFixit's Apple HomeView teardown found the display hard to remove because the aluminium case spreads heat and the screen glue is very strong.
- Speaker cables tore during disassembly, the motherboard used heavy thermal adhesive, and screws came in several formats from Torx to Phillips #00.
- The exposed board carries an Apple A18 chip, 8GB of SKHynix LPDDR5X memory and 64GB of Kioxia NAND storage.
- GSMArena's report gave no repairability score and did not cover parts prices or Apple's repair options for the HomeView.
In this article
What the teardown found
Repair specialist iFixit has taken apart the Apple HomeView and found a device that is difficult to open, according to GSMArena, which reported the results on 18 November 2026. The HomeView is a smart display with a 7-inch touchscreen and Siri with Apple Intelligence, and it went on sale more than a month before the teardown was published.
iFixit's presenter said the aluminium case carries heat away from the parts inside, and that this made removing the display harder than expected. The adhesive around the screen was also described as a much tougher glue than the material used in other recent Apple products. GSMArena called the overall design surprisingly difficult to repair, even by Apple's own standards.
Glue, mixed screws and torn cables

The problems continued once the screen was out of the way. The cables that connect the speakers were covered in large amounts of glue, and they tore when iFixit pulled the connectors apart.
Other important parts are fixed with screws in several different formats, ranging from Torx to Phillips #00. That means a repairer needs more than one type of driver to get through the device. The motherboard, the main circuit board, was held down with what the report calls an excessive amount of thermal adhesive, the heat-conducting glue used to move warmth away from chips.
There is more adhesive under the antennas and the speakers. iFixit reported that prying those parts loose took a lot of force.
Chips inside the HomeView
With the motherboard removed, iFixit photographed the main components. The Apple A18 processor sits alongside 8GB of SKHynix LPDDR5X memory and a 64GB Kioxia NAND flash module.
The LPDDR5X part is low-power RAM, the fast working memory a device uses while it is running. The NAND flash chip is the storage that keeps data when the power is off. Both are standard components in phones and tablets, and the A18 is the same chip family Apple uses in its recent iPhone models.
GSMArena's report did not mention a repairability score for the HomeView, and it did not cover the price of parts or the cost of a repair.
Why repairability matters here
Strong glue and mixed screw types usually make a repair slower and raise the chance of damaging parts on the way in or out. Torn speaker cables are a particular concern, because a cable that rips during disassembly can turn a small job into a bigger one.
The HomeView is a mains-powered household device rather than a phone, so it is likely to sit in a kitchen or living room for years. Owners who prefer to keep hardware running, or who use an independent repair shop, may find fewer options than with Apple's phones.
The available material does not say whether Apple sells HomeView parts or runs a repair programme for the device. Owners should check Apple's official support and repair pages for the current position before booking any work.
Sources
Spotted a mistake? See our corrections policy. Read how News by OnDevice works in our editorial policy.



