Smart home hub placement can affect how well devices work
Engadget explains how walls, routers and even microwaves can disrupt a hub's signal, and why a central, unobstructed position usually works best.

Key takeaways
- Engadget says the position of a hub can explain smart home faults that have no obvious cause.
- Walls, doors and furniture can block hub signals, so a central and open location is preferred.
- A hub belongs near the router for a strong signal, but not immediately beside it, to limit interference.
- Zigbee and Z-Wave mesh chains relay signals to the hub, though the signal weakens at each step.
In this article
What the report says
Smart home hub placement can be the reason a connected home misbehaves, according to Engadget, which published guidance on the topic on 16 November 2026. The publisher argues that where a hub sits deserves more attention than most owners give it.
Smart home devices often fail in ways that are hard to pin down, and Engadget lists position among the possible causes. A hub sits at the centre of a setup and can receive signals from every direction, so it seems sensible to put it anywhere. In practice, the location matters a lot.
Keep the path to devices clear
Many hubs carry controls for every connected device, which makes a central position an obvious choice. Owners who run separate apps for each product, or who rarely adjust settings by hand, may be tempted to hide the hub in a cupboard or behind furniture. Engadget warns that anything in the way can obstruct or impede the signals a hub has to send and receive.
The advice is to treat a hub much like a Wi-Fi router, even though not every smart home device uses Wi-Fi. Walls, doors and furniture can all block wireless communication, so a clear route between hub and device is better. Some devices will always sit further away and hold a weaker link, but a central position keeps those cases to a minimum. Where a hub has visible antennas, Engadget suggests pointing them towards the devices they serve.
Routers, microwaves and interference

Other transmitters in the home can disturb a hub as well. Wi-Fi routers are the main example, and Engadget says this kind of interference cannot be wiped out completely, especially in apartment buildings where many networks compete for the same airwaves.
The suggested compromise is a little distance. A hub should sit close enough to the router to pick up a strong signal, yet the two should never be placed right next to each other. Modern routers can switch to less crowded frequencies, and turning that option on, or setting the router and the hub to different bands, can cut congestion. Those bands are the separate radio ranges a Wi-Fi network can use. Phones and microwaves cause interference too, and here the only answer is to keep them away from the hub.
How mesh networks extend the range
Where a home leaves little freedom of placement, Engadget points to mesh networking as a workaround. Zigbee and Z-Wave, two widely used smart home radio standards, can pass a signal along a chain of devices until it reaches the hub. The range of that signal is fairly short, which is exactly the problem a chain solves.
In a mesh network, every device repeats the signal it receives, so the transmission from the hub only has to reach one other device for the network to work. The trade-off is that the signal grows weaker across multiple devices. A device near the hub will therefore do better than one at the far end of a long chain.
What owners can do next
Engadget's guidance comes down to a handful of practical steps. Choose a central and open spot for the hub rather than an enclosed one. Keep it within good range of the router without sitting it directly beside it, and separate it from phones and microwaves. Turn on any router setting that avoids busy frequencies, and aim external antennas at the rooms in use.
Hubs such as Anker's MindBase, which Engadget uses as an example, act as the control point for a whole system, so shifting one can affect every device attached to it. Anyone chasing a sensor that keeps dropping out may find that moving the hub helps more than resetting the device. The publisher offers this as general guidance rather than measured test results.
Sources
Spotted a mistake? See our corrections policy. Read how News by OnDevice works in our editorial policy.



